Nov 30, 2012
A buddy has entrusted his plasma cutter to me for the weekend. This thing is SOOOOO cool. Going to get a lot done today for sure.
So this weekend I'll be adding a few gussets, cutting a hole through the rear frame tube to mount a 2" receiver tube and notching the rear outboard frame to mount these leveling jacks.
Here's the three stages of the jacks:- fully retracted
- extended to it's mount height
- fully extended
There's room up inside the solid leg to extend the drop leg another 3-4". Doing so will give more overall lift. I'll also cut off the hand crank and weld on a HEX nut to use an electric drill. If the batteries runs out I'll be able to use my T-handle lug wrench.
No comments:
Post a Comment